The plumbing in your home is a major source of both utility and aesthetics. It’s the hidden force that keeps water flowing through your faucets, drains flowing properly, and toilets flushing cleanly. As such, it is essential to keep your home’s plumbing system in good working order so that any problems can be addressed before they become serious issues. This checklist will help you perform some basic maintenance on your home’s plumbing systems annually so that everything runs smoothly for years to come! Hire plumber st Kilda when in need!
Check your plumbing annually
- Check for leaks.
- Check for corrosion.
- Check for rust.
- Check for water flow, pressure and temperature.
- Check for hardness and quality of water.
Inspect the inside of toilets for rust, corrosion or leaks
Take a look at the inside of your toilet to see if there is any rust, corrosion or leaks. Check the flapper for leaks. Look at the water level in the tank, bowl and overflow pipe (at least 2 inches above overflow tube). Finally, check to make sure that there are no obstructions in the trap under your sink that could cause pooling or back-up of wastewater into your drain pipes.
Ensure that water is flowing freely from all faucets
In order to properly maintain your plumbing, you should perform the following tasks:
- Turn on all faucets and check for leaks. If there is a leak, turn off the water and call a plumber. Leaks can often be repaired by replacing the washer if it has become worn out over time or by tightening the screws that hold it in place.
- Test each of your faucets to ensure that they are working properly before shutting off any valves or turning off any valves that may cause damage to your property if they were left on while you were away from home
Clean the aerator to improve water flow.
If you have a low-flow shower head, the aerator could be clogged. You can clean an aerator by removing it from your faucet and submerging it in vinegar or hydrogen peroxide.
If you need to replace your aerator, you will need a screwdriver, pliers (or channel locks), and a wrench that fits the nut on top of the faucet. Turn off the water supply before removing any parts of your faucet system; then unscrew the old part using pliers or channel locks. To tighten nuts back onto new parts after installation, use one hand to hold onto threads while turning with other hand using either an adjustable wrench or box end wrench if necessary.
Conclusion
It is important to inspect every corner of the property by an expert plumber st Kilda to prevent plumbing issues. Inspect the inside of toilets for rust, corrosion or leaks. Ensure that water is flowing freely from all faucets. Clean the aerator to improve water flow.